Skip to content

Saniflo 008 Sanivite Drain Pump

SKU 008
by Saniflo
Original price $580.93 - Original price $580.93
Original price
$580.93
$580.93 - $580.93
Current price $580.93
Availability:
in stock

The Sanivite drain pump is used to pump gray water away from various fixtures in commercial and residential applications. The system can discharge the waste up to 16 feet vertical or 150 feet horizontal. This model is small enough to fit inside a kitchen cabinet and was designed to sustain the most demanding applications as it can handle hot water and grease.

Drain pump for kitchen installation or any gray water application

  • For commercial or residential applications
  • ↑ 16 Ft ↑ or ← 150 Ft →
  • Perfect quiet solution
  • Capability to handle hot water and grease buildup
          Carbon-neutral shipping with Shopify Planet
          Carbon-neutral shipping on all orders
          2,934kg
          shipping emissions removed
          That's like...
          7,510
          miles driven by an average gasoline-powered car
          We fund innovations in...
          Direct Air Capture
          Bio Oil
          Mineralization

          Specifications

          Weight16 lbs.
          Inlets (in)1 1/2'' vent (side) 2'' (sides)
          Power supply120 V - 60 Hz
          Shower/bathtub base min height6" min
          Noise level (measured at 3 ft.)≤ 44 dBA
          Horizontal discharge150 ft
          Vertical discharge16 ft
          Amperage (Amps)4.5 Max
          Operating maximum temperature140 F°
          Tank volume3.7 gallons
          Method of activationMembrane / microswitch
          Discharge rate at 3 ft29 gal/min (110 liters/min)
          Discharge rate at 16 ft18 gal/min (68 liters/min)
          Motor0.4 HP oil-filled thermally protected motor
          Capacitor rating (microfarad)18
          Power cord length (in)42 1/2
          Shut off head (ft)30
          Normal running time3-5 sec (short bursts)
          Certifying agenciesCSA (IPC, NSPC)

          Additional Product Information

          The Sanivite model was designed to sustain the most demanding applications meant for drain pumps. Its pumping capabilities and unique design are why this range of pumps is preferred for heavy-duty applications.

           

          The inside of the Sanivite is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the pump.

           

          When the water enters the Sanivite, it activates a micro switch in the pressure chamber, which starts the motor. The motor is sealed for life in an oil-filled enclosure. A spindle/shaft drives the impeller, and therefore the moving parts are kept to an absolute minimum. Water enters the chamber and is pumped away into the sanitary sewer. 

           

          The unit pumps the effluent upward to 16 feet or 150 feet horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the micro switch deactivates the unit until water enters the unit again. A standard operating cycle for the Sanivite can be as short as 2 - 10 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.

           

          In addition to a sink, the Sanivite will also accept and discharge the wastewater from various sanitary fixtures such as a shower, bathtub, urinal, and a whirlpool. When adding a bathtub or shower, a base will have to be constructed. This base should be made out of a 2" x 6" (minimum) or 2” x 8” (recommended) on edge to allow for the installation of a P-trap and the required 1/4” per foot gravity flow towards the pump unit.

           

          The Sanivite can also accept gray water from a washing machine through an indirect connection such as a laundry sink.

           

          The wastewater from other sanitary fixtures is discharged into the Saivite via two 2 inch inlets on either side of the housing and an additional 1 1/2" inlet on the top of the unit. Depending on the discharge installation, the discharge elbow on top of the Saivite can be turned either to the left, to the right, or towards the back. A non-return valve, which comes already assembled on the discharge elbow, prevents backflow into the unit.

           

          This unit has been designed with a vent connection on the lid. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent. Mechanical vents, air admittance valves, or similar devices are not permitted as these are considered one-way air vent systems.

           

          It is also highly recommended that the drain pump be connected to a Ground Fault Interrupter (GFI) circuit.

           

          The Sanivite is small enough to fit comfortably inside a kitchen cabinet or vanity or inside the overhang of a whirlpool.

          Certifications

          The Sanivite has been certified to American and Canadian Standards.  Electrical standard UL 778, CA:  Electrical standard CSA C22.2

          Downloads

          Interested in Deals and New Products?

          Keep up-to-date on deals and new home building products that benefit your health, your wealth, and the planet delivered right to your inbox.

          Skip to content