Skip to content

Saniflo 010 Sanishower Drain Pump

SKU 010
by Saniflo
Original price $406.74 - Original price $406.74
Original price
$406.74 - $406.74
Current price $406.74
in stock

The Sanishower drain pump is used to pump gray water away from various fixtures in residential applications. The system can discharge the waste up to 12 feet vertical or 100 feet horizontal. It is easy to install and small enough to fit underneath a shower base. It is ideal for medium-duty applications.

Residential drain pump for gray water applications

  • For medium-duty applications
  • ↑ 12 Ft ↑ or ← 100 Ft →
  • Small enough to fit underneath a shower base

      Delivery time / Order Processing & Shipping Times

      Rise ships manufacturer direct. We work hard so you receive your product(s) as quickly as possible. Learn more about our order processing & shipping times here.

      Carbon-neutral shipping with Shopify Planet
      Carbon-neutral shipping on all orders
      shipping emissions removed
      That's like...
      miles driven by an average gasoline-powered car
      We fund innovations in...
      Direct Air Capture
      Bio Oil


      Weight12 lbs.
      Inlets (in)2'' (sides)
      Power supply120 V - 60 Hz
      Shower/bathtub base min height5" min
      Noise level (measured at 3 ft.)≤ 44 dBA
      Horizontal discharge100 ft
      Vertical discharge12 ft
      Operating maximum temperature104°F (110°F Max.)
      Discharge pipe diameter3/4" or 1"
      Tank volume0.9 gallon
      Method of activationMembrane / microswitch
      Discharge rate at 3 ft20 gal/min (77 liters/min)
      Discharge rate at 12 ft14 gal/min (50 liters/min)
      Motor Speed (RPM)3600
      Motor0.2 HP oil-filled thermally protected motor
      Capacitor rating (microfarad)25
      Power cord length (in)48 1/2
      Shut off head (ft)26
      Normal running time3-5 sec (short bursts)
      Certifying agenciesCSA (IPC, NSPC)

      Additional Product Information

      The inside of the Sanishower is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the pump. When the water enters the Sanishower, it activates a micro switch in the pressure chamber, which starts the motor. The motor is sealed for life in an oil-filled enclosure. A spindle/shaft drives the impeller, and therefore, the moving parts are kept to an absolute minimum. Water enters the chamber and is pumped away into the sanitary sewer.


      The unit pumps the effluent upward to 12 feet or 100 feet horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the micro switch deactivates the unit until water enters the unit again. A standard operating cycle for the Sanishower can be as short as 2 - 10 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.


      In addition to sinks, the Sanishower will also accept and discharge the wastewater from various other sanitary fixtures such as a shower, a urinal, etc. When adding a shower, a base will have to be constructed. This base should be made out of a 2" x 6" (minimum) on edge, to allow for the installation of a P-trap and the required 1/4" per foot gravity flow towards the pump unit.


      The discharge elbow on the side of the Sanishower can be rotated 360 degrees to fit any type of installation required. A non-return valve, which comes already assembled on the discharge elbow, prevents backflow into the unit.


      This unit has been designed with a vent output on the top of the unit. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent. It is also highly recommended that the drain pump be connected to a Ground Fault Interrupter (GFI) circuit.


      The Sanishower is small enough to fit comfortably inside a kitchen cabinet or vanity or even under a raised shower base.


      As a point of interest, quite a few pedicure manufacturers are putting the Sanishower inside pedicure chairs. Due to its quiet operation and ease of installation, they have become the choice of OEMs.


      The Sanishower has been certified to American and Canadian Standards.  Electrical standard UL 778, CA:  Electrical standard CSA C22.2 


      Interested in Deals and New Products?

      Keep up-to-date on deals and new home building products that benefit your health, your wealth, and the planet delivered right to your inbox.

      Skip to content